Home »

How to Fix a JBL EON10 G2

So your JBL’s are rattling when you pick them up, eh? Getting that uneasy feeling about that clunky noise when you move them? If it’s the same unsettling noise I heard, then I have an easy fix for you. 1. Disconnect the speaker from all power sources.* 2. Place the speaker face down and open […]

March 28th, 2008 | Friends, Technology | , | Comments: 0

So your JBL’s are rattling when you pick them up, eh? Getting that uneasy feeling about that clunky noise when you move them? If it’s the same unsettling noise I heard, then I have an easy fix for you. 1. Disconnect the speaker from all power sources.* 2. Place the speaker face down and open up the shell by unscrewing all the screws around the outside edge. There’s like a million of them, so use a power drill with a long #2 phillips driver bit. 3. Lift the shell off and set it aside. Be careful not to lose any of the screws. 4. Locate the magnet coil and tighten the bolt that runs through the center.
5. Replace the shell. 6. Tighten all screws. 7. Enjoy your clunkless speakers. NOTE: I am NOT a licensed repairman, electrician, or lawyer. I have no idea if fixing this problem will void your warranty, so don’t blame me if/when JBL won’t service your speakers. Nor will I assume responsibility for you doing something stupid while dinking around with dangerous electronics. Make sure you unplug the speaker first and don’t touch anything inside. If you kill the speaker or yourself, I am not liable.

No Comments >

Leave a Reply